Table of Contents
Advertisement
24
S a b r i n a I n s t a l l a t i o n a n d C a r e
couple to the amplifier. These resistors are pre -installed and should not be
changed.
Replacing an Open Resistor
The resistors are designed such that they will open before damage occurs
to the corresponding driver. In the event a resistor is damaged, use the follow-
ing procedure to replace it.
•
Power off the amplifier.
•
Disconnect the speaker cable from the Sabrina.
•
Lay a terr y cloth towel or soft blanket on the floor adjacent to
the Sabrina to cushion the painted side of the loudspeaker.
•
Make sure to apply masking tape on the floor to mark the place -
ment of your Sabrina to ensure you can return them to their
proper location.
•
Carefully lay the Sabrina on its side. You will now have access
to the bottom access panel, under which is the crossover and
resistor access.
•
Remove the screws securing the crossover access panel with the
provided 1/8-inch ball-end wrench.
•
Identify the resistor that needs to be replaced.
•
Using a flathead screwdriver, remove the screws securing the
resistor to the plate. Take care to prevent the screws from drop-
ping into the enclosure.
G u i d e
A u t h e n t i c
E x c e l l e n c e ™
Advertisement
Table of Contents
