Table of Contents
Advertisement
S e c t i o n 3 . 3 — W i r i n g A t t a c h m e n t s
are also included for installations where spikes might damage the floor sur face
(such as wood floors).
After determining the optimal Sabrina position, assemble the spikes as
follows:
Assembly
1.
Screw the spike (with nut) all the way in until the nut just
touches the bottom of the enclosure. Do not tighten the nut at
this time. Three threads should be visible beneath the nut.
2.
Repeat steps 1 through 4 with the other spikes.
3.
Adjust the spikes so that the Sabrina is level.
4.
Using the 9/16" combination wrench, tighten the nut snug
against the diode to prevent the spike assembly from coming
loose.
Section 3�3—Wiring Attachments
Ver y high quality binding post connections are provided to facilitate con-
necting Sabrina to your amplifier. Locate the 1/2" nut driver from your tool kit.
Attach the main output from the amplifier to the binding posts located on the
bottom rear of the Sabrina. Use the 1/2" nut driver to tighten the binding posts.
W i l s o n
A u d i o
S p e c i a l t i e s
2 1
Advertisement
Table of Contents
