S E C T I O N 3 . 4 - R E M O V I N G T H E P R O T E C T I V E F I L - WILSON AUDIO Sabrina Installation And Care Manual

22
S a b r i n a I n s t a l l a t i o n a n d C a r e
Do not over tighten.
Section 3�4—Removing the Protective Film
To protect the finish of the Sabrina during final manufacture, shipment,
and setup in your listening room, we have applied a removable layer of protec-
tive film over the finish. We recommend that this film be left in place until the
speakers are in their final location in your listening room. Once you have deter-
mined their final position, remove the film by following this procedure:
1. Ensure the speaker sur face is room temperature before remov-
ing the protective film. Removing the protective film when the
speaker sur face is cold can damage the paint sur face.
2. Slowly remove the film from the top down, large sections at a
time, gently pulling the film downward and outward. Tearing
the film aggressively can damage the paint.
3. Take care in removing the protective film near edges and cor-
ners to prevent paint damage in these areas.
4. The protective film should not be left on the painted sur face
for extended periods of time nor exposed to heat sources and
direct sunlight.
G u i d e
A u t h e n t i c E x c e l l e n c e ™