Installing The Im 182 And Driver Software - Siemens SIMATIC HMI SICALIS PMC 7 Equipment Manual

Installation
Table 2-2 Entries in the registry
Parameter
SPC3BusPollTime
PLC3UserWatchdogTime
PLC3UserWatchdogValue The default preset value
BaseMemoryAddr
1)
Values less than 10 ms are unsuitable for the system.
2)
This preset value corresponds to the parameter "PLC3UserWatchdogValue" and is dependent on the
system configuration.
3)
The value is dependent on the bus configuration.
2.3.3

Installing the IM 182 and Driver Software

Installation
Shut Windows NT down and switch the device off. When installing the IM182 card
follow the instrucxtions in the manual and SIMATIC Box PC 820 operation guide.
Select the IM182 settings in accordance with the application's requirements.
Installation
Install the IM182 driver after the system has restarted. Place the diskette in drive A
and start the Install.cmd file. Follow the instructions in the read.me file.
Information regarding the PROFIBUS Interface Modul IM 182 can be found in the
SIMATIC DP, Windows NT Driver for IM 180 and IM 182 , Order No.
6ES7195-2AC00-0XA0 document (5 languages).
Afterwards, restart the computer.
2-14
Explanation
The PROFIBUS polling
time and monitoring the
IM182 operational status
[ms]
Poll time Taco-Lifecheck
and triggering the PLC3
users watchdog timers
[ms]
assigned to user
watchdog timer by driver.
Can be overwritten by
user's application.
Address of the IM182
card.
Entry made during the
installation of the
IM18x.SYS driver.
Registry Path
HKEY_LOCAL_MACHINE\SYSTEM\
CurrentControlSet\Services\Sikey\
Parameters
HKEY_LOCAL_MACHINE\SYSTEM\
CurrentControlSet\Services\Sikey\
Parameters
HKEY_LOCAL_MACHINE\SYSTEM\
CurrentControlSet\Services\Sikey\
Parameters
HKEY_LOCAL_MACHINE\SYSTEM\
CurrentControlSet\Services\IM18X\
Parameters
SICALIS PMC 7 Operator Panel Equipment Manual
Default
1)
100
2)
100
3)
1000
D8000h
Release 09/00