Siemens SIMATIC HMI SICALIS PMC 7 Equipment Manual page 15

Installation in a front panel
Step
1 From the front, place the operator panel into the prepared opening.
Take suitable measures to prevent the operator panel from falling out of the front
panel while it has not been firmly fixed in position.
2 Insert the 8 screw clamps into the corresponding slots in the operator panel
case.
The position of the clamps is shown in the illustration (Pos. 1).
3 From the back of the front panel, use an Allen key to tighten the screw clamps to
fix the operator panel firmly.
Make certain that the gasket is properly seated to seal the operator panel to the
front panel.
SICALIS PMC 7 Operator Panel Equipment Manual
Release 09/00
Procedure
1
1
1
1
Stud screws
Allen key
1
1
1
1
Screw clamp
Rear of OP
Installation
2-3