Electrical Installation; Installing The Keyboard And Mouse; Touch-Screen Version Scd 1297-Kt - Siemens SCD 1297-K Operating Instruction

2.5

Electrical Installation

Before applying power to the SCD 1297-K, check that all connectors are plugged in correctly
and secured. If a VGA signal is present, a picture should appear immediately on the display.
2.6

Installing the Keyboard and Mouse

When a computer starts up it usually checks and initializes the keyboard and mouse. If either
is not connected or is connected incorrectly, the computer's start up procedure may stop or
else the input device may not be available after it has been subsequently connected. This is
especially applicable when a mouse is connected to a PC compatible computer after it has
booted up.
The keyboard and/or the mouse should not be plugged in or unplugged while the computer is
running. This could result in misinterpretation of the keyboard codes/mouse signals.
Therefore, the control panel should always be switched on before or at the same time as the
computer system so that the keyboard and mouse are recognized and initialized correctly.
2.7

Touch-screen version SCD 1297-KT

SW driver is needed for the operation of the Touch. It can be downloaded form the web page:
www.siemens.com/displays
Control panel SCD 1297-K
Page 51 / 66
Operating instruction
DOC-Nr.: b40010de1.doc