Toshiba 100CS Manual page 97

When Alarm Volume is selected, the subwindow below is displayed to let
you enable or disable certain functions.
LOW BATTERY Alarm
Panel Close Alarm
(g) System Beep
Use this feature to enable or disable the system beep.
(h) Panel Power On/Off
This option allows you to automatically turn your computer on or off by
opening or closing the display panel. If this feature is enabled when the
computer is in Resume mode, the system is automatically powered off when
the display panel is closed and powered on when the panel is opened. This
option does not appear when the computer is in boot mode.
NOTE: Do not remove the AC cable and battery pack at the same time
when you use this feature. If you do so, data saved by AutoResume will
be lost. You must also reset this option.
(i) Alarm Power On
This option lets you set the time for the system to turn on automatically. For
example, if you are expecting to receive a modem transmission at a time you
are away or asleep, you can set this option to the time of the transmission.
This option does not automatically turn off the system. This feature operates
in either Resume or boot mode.
NOTE: Do not remove the AC cable and battery pack at the same time
when you use this feature. If you do so, the setting will be lost. You
must reset this option when you restore power.
3-58
ALARM VOLUME OPTIONS
Enabled
Enables the feature. (Default)
Disabled
Disables the feature.
Enabled
Enables the feature. (Default)
Disabled
Disables the feature.
Enabled
Enables the feature.
Disabled
Disables the feature. (Default)
00:00:00
Sets the power on time (24-hour clock).
Disabled
Disables the alarm.
= Enable
= Enable
100CS