Toshiba 100CS Manual page 2

K Parallel port
This port can be used to connect a Centronics compatible printer or other parallel
device. The port supports ECP (Extended Capabilities Port) conforming to
IEEE·1284.
K Serial port (9-pin)
The serial controller is 16550UART compatible. This port can be used to connect such
serial devices as a serial printer, serial mouse, or external modem.
K RGB port
The female, 15-pin, D-shell connector can be connected to an external SVGA monitor.
K Ext. Keyboard/Mouse port
Either a PS/2 compatible keyboard or a PS/2 compatible mouse can be connected to
this port. The computer automatically recognizes which device is connected.
K PC card slot
A PC card slot supports up to two Personal Computer Memory Card International
Association (PCMCIA) standard version release 2.0 cards. The upper and lower slots
can each accommodate one Type II (5.0 mm) card, or the lower slot can accommo-
date one Type III (10.5 mm) card when the upper slot is empty.
K Enhanced port replicator port
This port enables connection of an enhanced port replicator. The enhanced port
replicator has two PC card slots (Type III), and expands connections to the following
devices: PS/2 keyboard, PS/2 mouse, serial port, parallel port, external CRT, AC-in,
and AC-out. The NoteDock does not support the following ports: floppy disk, audio
in - audio out, joystick, and selectable ID.
K AccuPoint
A pointer control stick, located in the center of the keyboard, provides convenient
control of the cursor without requiring desk space for a mouse.
1-2
100CS