Toshiba 100CS Manual page 125

4.11 AC PS Unit
Removing the AC PS unit
To remove the AC PS unit, follow the steps below and refer to figures 4-21 and 4-24.
1. Turn the computer off. Disconnect the AC power cord and all external cables
connected to the computer.
2. Remove the battery pack, optional PC card, optional memory module, HDD,
keyboard, sub-battery and VGA board, top cover and display assembly, membrane
switch, and FDD as described in sections 4.2 through 4.10.
Disconnect the AC power cable from PJ502 on the system board and remove
3.
the tape from the cable (note that the cable is threaded under the FDD).
Remove one M2.5x6 screw and lift out the VGA cable guard .
4.
Remove one M2.5x6 screw securing the holder assembly and one M2.5x10 silver
5.
screw securing the AC PS unit .
6. Remove tape securing the holder assembly at the back of the AC PS unit.
7. Lift the AC PS unit out partially and remove it from its plastic base.
8. Turn the AC PS unit out on its side.
4-26
Figure 4-23 Removing the AC PS unit
100CS