Pentair AUTOTROL MAGNUM 742 Installer Manual page 46

Installer Manual Magnum 742-762 - Programming
9. "PM"
10. "MIN"
11. "g/L"
12. "KG"
13. "x100"
3
14. "Lbs/ft "
15. Faucet
16. Maintenance interval
17. Digits
18. Number
19. History values (H)
20. Parameter (P)
21. Cycle (C)
22. Hardness
23. Capacity
24. "x2"
25. Recycle sign
26. Salt
27. Regeneration time and
day
28. Time and day
46 / 106
Indicates that the time displayed is between 12:00 noon and 12:00
midnight.
"PM" indicator is not used if the clock mode is set to 24-hour (there is
no AM indicator).
Indicates that the value entered/displayed is in minute increments.
Indicates that the value entered/displayed is in grams/Liter.
Indicates that the value entered/displayed is in kilograms or kilograins.
x100 multiplier for large values.
Indicates that the value entered/displayed for regenerant amount is in
pounds per cubic foot.
Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
Displayed when the month in service exceed the value programmed in
parameter P11.
Four digits used to display the time, program value or error codes.
Used with #19, #20 and #21.
Displays a sequence number or value.
The number displayed by #18 identifies which history value is currently
displayed.
Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
The number displayed by #18 is the current cycle in the regeneration
sequence.
Hardness setting - only used with 760 and 762 controllers.
Shows estimated system capacity.
Indicates a second regeneration has been called for.
Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
Programming the amount of regenerant.
If the controller is on a 3-cycle filter then the backwash time is
displayed.
Programming the time of regeneration and the days of regeneration.
Programming the current time and day.
Ref. MKT-IM-012 / C - 25.10.2019