MG MGA Twin Cam Workshop Manual page 67

Addendum:
From time to time there were additions, deletions, and corrections to the Workshop Manual. The
following notes will detail some of these changes. Notice that when certain Sections were added or
deleted the Section numbers could change.
Section A.26 - last paragraph: Issues 1 and 2 of the Manual had an error noting that crankshaft thrust
washers, should be installed with oil grooves TOWARD the bearing. This copy (Issue 3) has corrected
this error, noting the thrust washers should be installed with oil grooves AWAY from the bearing
(toward the rotating flange of the crankshaft). Refer to Confidential Service Memorandum MG-416.
Section A.29 - from prior issues: This section was printed in prior issues but was not included in Issue
3:
Section A.44 - from prior issues: This section was printed in prior issues but was not included in Issue
3:
18G284A. Main Bearing Cap
Removal Adaptor
For use with impulse extractor
18G284.
18G309. Extractor
For use when removing the
half-speed shaft sprocket,
distributor drive gear, and
crankshaft gear.
67
©2018 morrisgarages.ch