Removing And Replacing The Rear Light - MG MGA Twin Cam Workshop Manual

Hide thumbs Also See for MGA Twin Cam:
Table of Contents

Advertisement

Fig. S.4 Inserting the cord in the outside tip of the rubber channel after fitting the plated finisher
Seelastik sealing compound should be injected between the outer lip of the rubber seal and the body
and between the seal and the glass. The application must be evenly distributed round the windshield.
To ensure this the outside lip should be firmly pressed down, with the fingers or a wooden roller, to
spread the sealing compound under the rubber seal.
Fig. S.5 shows the method of applying Seelastik sealing compound between the channel lip and body
flange, using an Expandite pressure applicator gun, if possible, fitted with a special 3/16 in. (4.5 mm.)
bore brass tube nozzle.
Refit the driving mirror.
S.14 REMOVING AND REPLACING THE REAR LIGHT (COUPÉ
)
Push the glass, and rubber seal, towards the outside of the car until it is free.
To replace, fit the rubber seal round the glass. Thread a length of cord along the inner flange of the
rubber seal with the ends protruding.
With the aid of a second operator to apply hand pressure to the outside of the glass draw the string
from the rubber seal so that the flange is lifted over the metal edge of the window opening.
Seelastik sealing compound should be injected between the outer lip of the rubber channel and the
body flange.
260
©2018 morrisgarages.ch

Advertisement

Table of Contents
loading

Table of Contents