MG MGA Twin Cam Workshop Manual page 200

place by soldering. The brushes are pre-formed, so that bedding of the working face to the
commutator is unnecessary.
Drive
If the pinion is tight on the sleeve, wash in paraffin; replace any worn or damaged parts.
To dismantle the drive, extract the split pin and remove the shaft nut "J" (Fig. N.5); withdraw the main
spring and collar.
Rotate the barrel to push out the sleeve; remove the barrel and pinion.
The barrel and pinion are supplied as an assembly, but the parts may be separated by extracting the
Fig. N.5. An exploded view of the starter and drive.
Fig. N.6. An expander in use for fitting pole shoes.
200
©2018 morrisgarages.ch