Cautions For Rack-Mount - Ikegami HLM-7012WR Operating Instructions Manual

WARNING
4. Cleaning
1) Unplug this television equipment from the wall
outlet before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for cleaning.
2) Do not use thinner or benzene for cleaning.
Otherwise, the cabinet may deform or the paint
may peel away.
5. Repair
1) Unplug this equipment from the wall outlet and
refer servicing to qualified service personnel under
the following conditions:
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the television.
c. If the television monitor has been exposed to rain
or water.
d. If the equipment does not operate normally by
following the operating instructions.
Adjust only those controls that are covered by the
operating instructions as improper adjustment of
other controls may result in damage and will often
require extensive work by a qualified technician to
restore the equipment to normal operation.
e. If the equipment has been dropped or the cabinet
has been damaged.
f. When the equipment exhibits a distinct change in
performance - this indicates a need for service.
2) When replacement parts are required, be sure the
service technician has used replacement parts
specified by the manufacture that have the same
characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, or injury to persons.
3) Upon completion of any service or repairs to this
equipment, ask the service technician to perform
routine safety checks to determine that the
equipment is in safe operating condition.
4) For repair service, contact Ikegami's authorized
sales representative or Ikegami service desk directly.

Cautions for Rack-Mount.

A) Elevated Operating Ambient - If installed in a closed or
multi-unit rack assembly, the operating ambient temperature
of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum
ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack
should be such that the amount of air flow required for safe
operation of the equipment is not compromised.
C) Mechanical Loading - Mounting of the equipment in the rack
should be such that a hazardous condition is not achieved
due to uneven mechanical loading.
D) Circuit Overloading - Consideration should be given to the
connection of the equipment to the supply circuit and the
effect that overloading of the circuits might have on
overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be
used when addressing this concern.
E) Reliable Earthing - Reliable earthing of rack-mounted
equipment should be maintained. Particular attention
should be given to supply connections other than direct
connections to the branch circuit (e.g. use of power strips).