Maintenance, Repair - Bosch Rexroth PSI 6500 Series Technical Information

1070087059 / 02 PSI 6500.xxx
Safety Instructions
1.9

Maintenance, Repair

DANGEROUS ELECTRICAL VOLTAGE
Prior to any maintenance work - unless described otherwise - the
system must always be switched off and sufficiently secured!
In the event of necessary measurement or test procedures on the
active system, these have to be performed by skilled electrical per-
sonnel.
DANGER
Lithium batteries can cause skin burns or explode in case of im-
proper handling!
Therefore, do not forcefully open batteries, do not attempt to
charge or heat up batteries over 1005C!
CAUTION
Please use only spare parts approved by us!
Use only original replacement batteries! In any case, spent batte-
ries and accumulators should be disposed of as hazardous waste!
CAUTION
Danger to the module!
All ESD protection measures must be observed when using the
module! Prevent electrostatic discharges!
The following protective measures must be observed for modules and
components sensitive to electrostatic discharge (ESD)!
D Personnel responsible for storage, transport, and handling must have
training in ESD protection.
D ESD-sensitive components must be stored and transported in the
prescribed protective packaging.
D ESD-sensitive components may only be handled at special ESD-
workplaces.
D Personnel, working surfaces, as well as all equipment and tools
which may come into contact with ESD-sensitive components must
have the same potential (e.g. by grounding).
D Wear an approved grounding bracelet. The grounding bracelet must
be connected with the working surface through a cable with an inte-
grated 1 MW resistor.
D ESD-sensitive components may by no means come into contact with
chargeable objects, including most plastic materials.
Electric Drives Bosch Rexroth AG
and Controls
1-11