Installing And Connecting The Ozonizer; Connecting The Ozonizer With Skimmer / Ozone Reactor Operation With Air Stones; Alternative: Connecting The Ozonizer With Skimmer With Injector - Sander XT 2000 Instruction Manual

Installing and connecting the Ozonizer

Proposal A: Wall mounting
On the rear of the ozonizer is a suspension clip for mounting
the ozonizer on a wall. If possible, the device should be
installed at a level higher than the surface of the water of the
aquarium (e.g. to prevent water from flowing back into the
device in the event of a power failure).
Proposal B: Cabinet installation
The ozonizer can also be installed in the cabinet under the
aquarium (ensure adequate ventilation). In this case,
however, a tube that extends at least 20cm above the surface
of the water should be fitted to prevent water from flowing
back into the ozonizer.
Connecting the Ozonizer with Skimmer / Ozone Reactor Operation with air
stones
The ozonizer has two tube connections.
The right connection (5) is connected to an air tube (ø 6 x 1) leading to an air pump. The left
connection (6) on the ozone element (7) is connected to the air stones via the skimmer. Using the
control buttons, the ozone output can be adjusted from 0-100%.
If ozone production is deactivated while the ozonizer is still connected to the skimmer, the air supply
must remain switched on. This stops water from entering the ozone generator.

Alternative: Connecting the Ozonizer with Skimmer with Injector

Connect the injector to the left output (6). The air is automatically sucked through the ozone
generator. To avoid contamination by airborne dust, it is recommended to draw the air in through a
filter at the air inlet (5).
Revision status 23.05.2016
7