Instructions For Laboratory Tests - Brandt VI 310 Operating Instructions Manual

Présentation de votre lave-vaisselle Troubleshooting, what to do?
Poor operation Possible causes
Traces of rust on stainless - The quality of the stain-
steel less steel (in knives in
particular) is unsuitable
for washing in a machine.
Poor washing results Possible causes
A lot of drops on the - Insufficient or no rinse
glasses aid.
- The dose has not been
distributed.
- Position of the items.
Drops on plastic glasses, - These insulating items
Tefal coatings, etc. have a low calorific
mass.
Drying is less good in - In the rapid pro-
rapid programmes. grammes, the drying
temperature and the
drying time are reduced
to restrict the length of
the cycle to a minimum
level.
Condensation on the - Condensation may form
walls of the inner door or on the walls, particular-
the tub. ly after cooling down
(sound insulation
increases its occurren-
ce).
52
What to do
- Use special "dishwa-
sher-safe" cutlery
- Check that the salt pot's
stopper is firmly closed.
What to do
- Check the indicator light
and fill the reservoir
completely.
- If the reservoir is not
empty after approxi-
mately 60 washes, call
an engineer.
- To relieve the problem,
arrange the items so as
to restrict as much as
possible any water
retention: if possible,
leave the door ajar for a
few minutes.
- Arrange them optimally,
prioritising the use of
the upper basket if pos-
sible.
- Select the most appro-
priate rapid programme.
GB

Instructions for laboratory tests

Arrange the items as shown in Figures A – B – C (see following page)
in accordance with EN 50242 : standard: "Bio" Programme
and the Mixed method (IEC 436/DIN 44900) :
✔ Washing capacity
✔ Detergent dose
in accordance with EN 50242 :
and the Mixed method (IEC 436/DIN 44900) :
✔ Detergent dispenser setting
✔ Setting for the upper basket
✔
Loaded in accordance with the instructions on the
following page, with no side shelves.
✔ The water softener MUST be set to a setting
immediately higher than that recommended,
depending on the water hardness, to take into
account the lack of phosphate in standardised
detergents.
✔
For more information on the comparison tests in
accordance with EN 50242 regarding the level of
soiling, the type of items, etc., please contact the
manufacturer of the machine before commencing
testing.
GB
12 standardised
place settings
30g of detergent B
5+25 g of
detergent B
3
High position
53