Basic Functions; Plug And Play - Philips FW-C785/25 User Manual

Basic Functions

FW- MINI HIFI SYSTEM
STANDBY-ON
ECO POWER
DISPLAY
DEMO
PLAY•
STOP/
PAUSE
CLEAR
IMPORTANT!
Before you operate the system, complete
the preparation procedures.

Plug and Play

Plug and Play allows you to store all available
RDS stations and radio stations automatically.
If Plug and Play has not been installed
1
When you turn on the system, "AUTO
INSTALL - PRESS PLAY" will be displayed.
2
Press PLAYÉ on the system to start
installation.
➜ "INSTALL" will be displayed and followed by
"TUNER" and then "AUTO".
➜
will start flashing.
PROG
➜ The system will search for all RDS stations
and then continue with radio stations on FM,
MW and LW band respectively. Weak RDS
stations may be stored in later presets.
➜ All available RDS and radio stations with
sufficient signal strength will be stored
automatically.
➜ The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
➜ The last preset radio station or the first
available RDS station will play when Plug and
Play is completed.
3
The system will proceed to set the RDS time
automatically with the stored RDS preset station.
G If no RDS station is found in the first preset
station;
➜ The programme will exit automatically.
12
pg 001-029/C785/22-Eng
MUSIC LEVEL VOLUME
INTERACTIVE VU METER
CLOCK• AUTO
PROG DUBBING REC
TIMER REPLAY
CD 1•2•3 BAND
CD TUNER
SOURCE
ON • OFF WOOX LEVEL
OO
TAPE AUX W X
DYNAMIC
AMPLIFICATION
CONTROL
TAPE 1•2 CDR / DVD
G If RDS radio station is found;
G When searching RDS time;
1
2
G Press Çon the system.
12
VOLUME
ATION - JOG
➜ "INSTALL" will be displayed and followed by
"TIME".
➜ "SEARCH RDS TIME" will be displayed.
➜ When RDS time is read, "RDS TIME" will be
displayed. The current time will be displayed for
2 seconds and stored automatically.
➜ If RDS station does not transmit RDS time
within 90 seconds, the programme will exit
automatically and the display will show "NO RDS
TIME".
To reinstall Plug and Play
In Standby or Demonstration mode, press and
hold PLAYÉ on the system until "AUTO
INSTALL - PRESS PLAY" is displayed.
Press PLAYÉ again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
– If no stereo frequency is detected during
Plug and Play, "CHECK ANTENNA" will be
displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.
12/11/01, 5:35 PM
3139 115 21201