Sleep Timer Setting - Philips FW-C785/25 User Manual

Clock/Timer
2
Press CD, TUNER or TAPE to select the
desired source.
G Before setting timer, make sure the music source
has been prepared.
CD – Load the disc(s). To start from a specific
track, make a programme (refer to "CD
Operation - Programming the disc tracks").
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 2.
3
Press à or á on the system repeatedly to set
the hour for the timer to start.
4
Press í or ë on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK•TIMER to store the start time.
➜ "TIMER ON" will be displayed and followed
by the set timer "XX:XX" and then the selected
source.
➜
will remain on the display.
TIMER
G At the preset time, the selected source will play.
To exit without storing the setting
G Press Çon the system.
Notes:
– If the selected source (CD) is not available when
preset timer is reached, TUNER will be selected
automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
G Press TIMER ON/OFF on the remote control.
➜ The display will show "CANCEL" and
will disappear from the display.
To activate the TIMER
G Press TIMER ON/OFF on the remote control.
➜ The last set timer information will be shown
for a few seconds and
the display.
26
pg 001-029/C785/22-Eng
TIMER
will appear on
TIMER
26

Sleep Timer Setting

The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 ...
➜ "SLEEP XX" or "OFF" will be displayed. "XX"
is the time in minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
➜
will appear on the display, except for
SLEEP
"OFF" mode.
➜ The Sleep Timer is now set. Before the
system switches to standby mode, a countdown
of 10 seconds will be displayed.
"SLEEP 10" ™ "SLEEP 9".... ™ "SLEEP 1"
™ "SLEEP"
While SLEEP mode is activated
To check the remaining length of time
G Press SLEEP once.
To change the preset sleep timer
G Press SLEEP twice.
➜ The display will show the remaining time
followed by the sequence of sleep timer options.
To deactivate the Sleep Timer
G Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
12/11/01, 5:36 PM
3139 115 21201