Configuring Divisional Pistons And General Pistons - Allen Organ Company Protégé LD-34 Owner's Manual

2.

Configuring Divisional Pistons and General Pistons

This procedure enables pistons to control stops that are normally not controlled by those
pistons.
Note: The Piston Configuration is common to all capture memories.
For example:
(1) Divisional Pistons can be configured to respond like General Pistons.
(2) A Divisional Piston can be configured so that it will only affect the Tremulant stops in
all divisions.
(3) A General Piston can be configured to respond like a Divisional Piston.
Note 1: Changing the configuration of a piston will not affect the registrations previously
remembered by that piston prior to its reconfiguration.
Note 2: Reconfiguring a piston does not change its MIDI channel assignment.
Configuring Divisional Pistons to become General Pistons:
Advance to the 'CONFIGURE PISTONS' window function (see section A-2).
Select all of the stops. Any stops not lit, will not be able to be registered later. While holding
in the SET piston, press the Divisional piston that you want to respond like a General Piston.
Return to the Main Window to store General registrations to the Divisional pistons you
pressed (See Section A-4).
To reconfigure a Divisional Piston so it controls only the Tremulant stops/drawknobs:
Advance to the 'CONFIGURE PISTONS' window function (see section A-2).
Select all of the organ's Tremulant stops. Next press and hold SET. While holding SET,
press a Divisional piston. Return to the Main Window. You can use this reconfigured
divisional piston to control just the Tremulant Stops without affecting any other stops.
The use of the CONFIGURE PISTONS function is only limited by one's creative
imagination.
Remember: The above examples only determine which stops will become accessible by the
reconfigured pistons; they will not change previously saved registrations.
CONFIGURE
PISTONS
CONFIGURE
PISTONS
23