Implementation
Configuring the SPI communication
The configuration of the SPI communication is done through the function initQSPI() in two
different steps:
›
QSPI Slave initialization
›
QSPI Master initialization
QSPI Slave initialization
›
The initialization of the QSPI slave module is done by defining an instance of the
IfxQspi_SpiSlave_Config structure
›
The structure is filled with default values by the function
IfxQspi_SpiSlave_initModuleConfig()
›
Afterwards, the following parameters are modified to enable the DMA usage, set its
channels, interrupt priorities and IO port pins:
–
DMA configuration: dma.useDma, dma.txDmaChannelId, dma.rxDmaChannelId
–
Interrupts configuration: base.txPriority, base.rxPriority, base.erPriority,
base.isrProvider
–
Pins configuration: pins
2020-01-17
Copyright © Infineon Technologies AG 2020. All rights reserved.
6