Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
RDS stations and radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å on the system to start installation.
"PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
starts flashing.
PROG
The system will automatically store the radio
stations with sufficient signal strength, starting
from all RDS stations and followed by FM and
MW bands respectively. Weak RDS stations may
be stored in later presets.
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station (or the first available
RDS station) will be played.
12
(for tuner installlation)
3
The system will proceed to set the RDS clock if
the first preset is an RDS station.
"INSTALL" is displayed, followed by "TIME"
and "SEARCH RDS TIME".
When RDS time is read, "RDS TIME" is
displayed and the current time will be stored.
If RDS station does not transmit RDS time
within 90 seconds, the programme will exit
automatically and the display will show "NO RDS
TIME".
If the first preset is non-RDS station;
The programme will exit automatically.
To reinstall Plug and Play
1
In standby or demonstration mode, press and
holdÉ Å on the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
2
PressÉ Å again to start installation.
All previously stored radio stations will be
replaced.
y
CD1/2/3
TUNER
TAPE1/2
AUX
REP/SHUF
PROGRAM
DIM
VOL
TITLE
ALBUM
SLEEP
TIMER ON/OFF
MUTE
DSC
DBB