System Board Filler Replacement - Lenovo ThinkSystem SR950 Setup Manual

• If you are not installing another system board, install the compute tray and front cover. See "Install a
compute tray" on page 190 and "Install the front cover" on page 205.

System board filler replacement

System board fillers are in the upper or lower compute tray that is accessed from the front of the server.
Remove a system board filler
Remove a system board filler by pressing the release clips on the filler, and sliding it out of the compute tray.
S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove the system board filler:
1. Remove the front cover. See "Remove the front cover" on page 205.
2. Remove compute tray where the system board filler is installed. See "Remove a compute tray" on page
188.
Complete the following steps to remove the compute system board filler:
Watch the procedure. A video of the replacement process is available:
•
YouTube
•
Youku
Appendix B. Component reference
195