Raid Card Connectors - Lenovo ThinkSystem SR950 Setup Manual

Figure 57. Storage interposer connectors
Table 120. Storage interposer connectors
Callout
1
PCIe SAS interface from system board (PCIE) (SAS
only)
2
Drive power from system board (POWER)
3
Drive signal from system board (SIDEBAND)
4
Power for drive to backplane 1 or 6 (BP 1/6)

RAID card connectors

The following illustration shows the internal connectors on the RAID card.
There are two basic RAID card configurations.
Notes:
• The RAID cards in the illustration might be different than the RAID card in your system. Connector
locations for all RAID cards is similar.
• Some cable connectors have locks or latches that must be disengaged to disconnect the cable.
For information about RAID card cable routing, see "Cable routing for drives" on page 41.
Figure 58. RAID card connectors (type 1)
Table 121. RAID card connectors (type 1)
Callout
1
RAID flash power module (J14) connector
2
Unused
3
RAID connector for drive backplane 3 or 6 (SAS only)
172
ThinkSystem SR950 Setup Guide
Callout
5
Power for drive to backplane 2 or 5 (BP 2/5)
6
PCI connector to RAID card
7
Power for drive to backplane 3 or 4 (BP 3/4)
Callout
4
RAID connector for drive backplane 2 or 5 (SAS only)
5
RAID connector for drive backplane 1 or 4 (SAS only)
6
PCI connector to storage interposer