Electrical Safety - Black+Decker EGBL108 Original Instructions Manual

Chargers
• Use your BLACK+DECKER charger only
to charge the battery in the tool with
which it was supplied. Other batteries
could burst, causing personal injury and
damage.
• Never attempt to charge
non-rechargeable batteries.
• Have defective cords replaced
immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor
use only.
Read the instruction manual before
use.

Electrical safety

Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the
rating plate. Never attempt to
replace the charger unit with a
regular mains plug.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the
following features.
1. Variable speed switch
2. Forward/reverse slider
3. Chuck
4. Torque adjustment collar
5. Battery
6. Bit holder
Fig. A
(Original instructions)
7. Charger
8. Charging indicator
Assembly
Warning! Before assembly, remove the
battery from the tool.
Fitting and removing the battery (fig.C)
• To fit the battery (5), line it up with the
receptacle on the tool. Slide the battery
into the receptacle and push until the
battery snaps into place.
• To remove the battery, push the release
button (9) while at the same time pulling
the battery out of the receptacle.
Fitting and removing a drill bit or screwdriver
bit (fig. D)
This tool is fitted with a keyless chuck to
allow for an easy exchange of bits.
• Grasp the rear half of the chuck (3) with
one hand and use your other hand to
rotate the front half in the
counterclockwise direction, as viewed
from the chuck end.
• Insert the bit shaft (10) into the chuck.
• Firmly tighten the chuck by holding the
rear half of the chuck and rotating the
front portion in the clockwise direction as
viewed from the chuck end.
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery (fig.A)
The battery needs to be charged before first
used and whenever it fails to produce
su cient power on jobs that were easily
done before. The battery may become warm
while charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 4°C or above
40°C. Recommended charging temperature:
approx. 24°C.
ENGLISH
7