Transferring Another Terastation's Settings; Creating A Config File (.Nas_Config) - Buffalo TeraStation 6000 Series User Manual

Chapter 7 Advanced Features
3
Click the settings icon (
4
Select "Transfer settings from a USB drive".
5
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation, then click
Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will apply the settings. When applying settings is completed, click OK.

Transferring Another TeraStation's Settings

You can transfer saved settings from another series TeraStation to your TeraStation. The following settings can be
transferred:
• Shared folders which are created from "File Sharing" > "Folder Setup"
• Access restrictions
• Users
• Groups
Note: This feature currently supports the following TeraStation series as of November 2018. The latest compatibility
information will be on the
• TS-X series firmware version 1.58 or later
• TS3000 series
• TS4000 series
• TS5000 series
• TS3010 series
• TS5010 series
• TS6000 series

Creating a Config File (.nas_config)

Procedure for TS-X Series
To transfer settings from TS-X series TeraStations, it will use the "NS-SHFT" software to create a config file. The NS-
SHFT can be downloaded from the
For the procedure on creating the config file, refer to the NS-SHFT user guide.
) to the right of "Configuration Management".
Buffalo website.
Buffalo website.
174