Inserting The Tool Bits; Turning On And Off And Setting The Rotating Direction; The Led Light; Maintenance And Cleaning - Westfalia 94 17 24 Instruction Manual

Inserting the Tool Bits

A magnetic bit holder is included with the screwdriver. Tool bits
can either be directly inserted into the hex socket (1) on the
screwdriver or into the magnetic bit holder. Bits must be at least
25 mm long.

Turning ON and OFF and setting the Rotating Direction

With the switch (2) the motor is turned on
and off and at the same time the rotating
direction is set.
Press the upper part of the switch for
counter-clockwise rotation and the lower
part for clockwise rotation.
When the switch is released, the screwdriver immediately
stops.

The LED Light

Just above the bit socket you will find the
lamp (5). With this lamp you can work
quickly and efficiently even in poorly lid
areas.
The switch (6) for the lamp is located on
the top of the housing. Push the switch
forward to turn on the lamp.

Maintenance and Cleaning

The screwdriver does not require maintenance and does not
contain parts serviceable by you. In the case of a malfunction
please contact the Westfalia customer support department.
Do not use water or liquids of any kind to clean the battery
powered screwdriver. Use only a moist, soft cloth.
Using
11