Setting Ethernet-Modems With The Configuration Tool - Siemens SIPROTEC 4 Manual

Setting Ethernet-modems with the configuration tool

All modems are factory pre-set on delivery; this setting must be adapted to the individual
applications. This may in principle be done with a terminal program via the RS232 interface,
the simplest method however being the use of the configuration tool on a PC which is
connected to an Ethernet modem with a crossed patch cable.
The installation of the configuration tools is described at length in the Ethernet modem
manual; the crossed path cable is included in the scope of delivery.
When the Ethernet modem is supplied with auxiliary voltage and connected to the operating
PC via the crossed patch cable, the configuration tool is started. The modem should be
found immediately after the start.
Note: In this example, the operating PC is allocated with fixed addresses.
IP-address:
Sub-net mask:
HELP_DIG4_SIP4_ETHERNET_A2.DOC
192.168.10.100
255.255.255.0
Seite 8 von 21
Power Transmission and Distribution
Energy Automation
28.11.2005