V-fit-ST Herculean LFG2 Assembly & User Manual page 19

Assembly
Stage G.
16). Fit the Backrest Support (4) to the bracket on the Front Upright using 1 x M10 x 60mm Hex Bolt (28), 2 x M10 Flat
Washers (38) and 1 x M10 Nylon Locknut (35).
Note: - This MUST be fitted into the FRONT hole in the bracket. Fit the Backrest Lock-Pin (42) into the REAR hole in the
bracket to lock the Backrest Support in place.
17). Fit the Leg Extension Upright (12) to the Front Stabiliser (19) using 2 x M10 x 55mm Hex Bolt (27), 4 x M10 Flat
Washers (38) and 2 x M10 Nylon Locknut (35). Fit the Leg Extension Upright (12) to the front of the Backrest Support
using 1 x M10 x 55mm Hex Bolt (27), 2 x M10 Flat Washers (38) and 1 x M10 Nylon Locknut (35). Locate 1 x M8 x 55mm
Carriage Bolt (33) into the top hole in the front of the Backrest Support and lock the Leg Extension Upright in place using
1 x M8 Knob (50), fitted from underneath.
38 35
42
38 35
04
33
28
27
50
12
19
38
35
27
Page 19