Folding The Bench For Storage - V-fit-ST Herculean LFG2 Assembly & User Manual

1. Remove the M8 Knob (50) fitted to the underside of the Backrest Support (4) at the FRONT by the Leg Extension Upright (12).
2. Remove the Backrest Lock Pin (42) from the Pivot Bracket at the rear
of the Backrest Support (4).
42
4. Carefully lift the front of the Bench / Backrest then fold the Leg Unit down.
Wrap the Link Cable around the Backrest Support as shown and secure the Bench
in place, fastening the 2 ends of the Link Cable using the 2 Pec Dec Arm
Lock Pins (42A).
42A
49A
6. To prepare the Gym for use again, carefully reverse
the above procedure noting that the upright Backrest
will be heavy when released.
Assembly

FOLDING THE BENCH FOR STORAGE

42A
60
50
3. Remove the Link Cable (49A) from the Lat Bar Support Hook.
5. For added security, re-fit the Backrest Lock Pin (42)
from the Pivot Bracket at the rear of the Backrest Support
(4), which was removed in Step 2 above.
7. When your gym is not in use, making sure to place the Weight Selector Pin (41) into the
loop on the back of the Base Frame U Bracket (22) which will lock the Selector Shaft
(16) to lock all Weight Stacks (60) firmly.
22
16
49A
42
60
16
41
22
Page 25