Scott Foil Di2 Assembly Manual page 15

Enlarged version

Push the internal junction box slightly into the downtube. Place the Shimano

press fit bottom bracket in such a way that the cables are not squeezed. Press

the bottom bracket into the frame using the correct Shimano tool. Place the

rubber piece into the hole under the bottom bracket.

Mount the Shimano Direct Mount rear brake. Pull the brake cable out of the hole on the downside of the downtube. Here again, a

spoke might help to get the cable out of the frame.

Place the cable stop and measure the

housing to the correct length. Make sure

the cable can always move freely when full

brake force is applied.

Fix the brake cable on the Shimano Direct Mount rear brake.

FOIL BUILD UP MANUAL / SCOTT / FOIL / 2016