Advertisement
Install the cockpit and loosely tighten the screw of the top cap.
Insert the rear cap and position it correctly by lifting the stem about 1-2mm. Continue by tightening the top cap screw until the
head set play is balanced. Finish the handlebar mount by tightening the stem to a maximum of 5Nm. Use a torque wrench to
ensure that you don't overtighten the stem bolts.
18
Insert the cables into the opening on top of the downtube
and push them down until they appear at the bottom bracket
opening of the frame.
FOIL BUILD UP MANUAL / SCOTT / FOIL / 2016
Fix the Di2 wire that goes into the frame to
the rear brake cable with a piece of tape.
This will facilitate pushing both cables
through the frame. Make sure the shrinking
tube and cable guide have been installed
according to the above description before
you proceed with this step.
19
Advertisement
