Back - Sunrise Medical Quickie Argon Directions For Use Manual

Options – Back
Angle adjustment of the folding backrest:
1. Open the upper screws and
loosen the screw connection
(Figure 1).
2. The hole in the back tube must
be lined up with the hole in the
connecting part, such that you
can set the desired backrest
angle (Figure 2).
3. Fit the screw connection with
the nut and washer until they are
hand tight, so that there is no
lateral play between the compo-
nents. But you must still be able
to fold the back tube down
easily.
4. Set the folding mechanism: To
do this, loosen the nuts on the
cam slightly (Figure 3). Set the
cam (component 1) such that
the folding mechanism locks
into place with no play (if
necessary use a 10 mm open-
ended spanner to do this). Then
hold the cam in position and
tighten the nuts (5 Nm).
5. Repeat steps 1 to 4 for the
second side.
Adjustable back sling
The adjustable back-sling can be
adjusted for tension by using
several straps.
The back-sling upholstery can be
accessed from the inside via an
opening and can be upholstered to
suit individual tastes
Height adjustable backrest
The backrest height can be adju-
sted to 5 different positions (38–48
cm). Open and remove the bolt (1)
and move the back tube into the
desired position. Then fix the bolt
again.
Standard sideguard, flip-up,
removable with short or long
arm pads
With the sideguard which is step-
ped down at the front it is possible
to move up closer to a table. To flip
them up press the lever (G) for-
wards, so that the sideguard is
released.
ATTENTION!
Sideguards, and the armrests
are not designed to be used to
lift or carry the wheelchair.
0505/2/ST-000690644.EMS 1B
Figure 1
Figure 2
Figure 3
1
Sideguard, flip-up, removable with short or long arm pads,
height-adjustable
The arm pad can be height-adjusted in the following way. Pull the
lever (1) and adjust the arm pad (2) to the desired height. Release
the lever and push the arm pad (2) down until you hear it click into
place.
ATTENTION!
Sideguards, and the armrests are not designed to be used to
lift or carry the wheelchair.
Options – Armrest
Quickie – height adjustable armrest
1. Fitting
a. Push the outside armrest support into the clamp which is moun-
ted on the chair frame.
b. The armrest will automatically lock into place.
2. Height adjustment
a. Turn the release lever to the second position.
b. Push the arm support up or down to the required height.
c. Turn the release lever back to the armrest locking position.
d. Push the arm support in until the upper armrest locks into positi-
on.
3. Removing the armrest
a. Turn the release lever to the first position and remove the arm-
rest.
4. Changing the armrest
a. Push the armrest back into the clamp.
b. Turn the release lever back to the armrest locking position.
5. Adjusting the fit of the armrest receiver
To tighten or slacken the fit of the outside armrest in the clamp:
a. Release the four bolts on the sides of the clamp.
b. Hold the armrest in the clamp and squeeze the clamp together
at the required fit.
c. Tighten up the four bolts.
6. Adjusting the fit of the inner armrest
a. The outside armrest is fitted with two stud bolts.
b. Turn stud bolts in or out as required until you have found the
desired fit.
9
ARGON