SenseAir aSENSE Installation Manual

Gas and air sensors

Hide thumbs Also See for aSENSE:

Gas and Air Sensors

Push the front part upwards while

keeping the wall plate steady

Installation Manual

aSENSE

1 top part

2 front part

3 wall plate

4 screw

5 label with

settings

inside the

top part

Pull the top part upwards

Fold the front part forwards and

loose it from the hooks (#1)

Document

Rev

IMA0195

Page

1 (4)

Table of Contents

Do you have a question about the aSENSE and is the answer not in the manual?

Page 1: Installation Manual
Gas and Air Sensors Installation Manual aSENSE Dismounting of the sensor 1 top part 2 front part 3 wall plate 4 screw 5 label with settings inside the top part Pull the top part upwards Push the front part upwards while...
Page 2 The screw head diameter should be max 7,5 mm The screw head height should be max 2,5 mm The top part is pushed under the Terminals and jumpers on aSENSE. locking hooks of the wall plate The darker positions are default settings.
Page 3: Electrical Connections
(halfwave rectifier). A single transformer may be used for the entire system. Note 2: aSENSE can deliver a voltage or a current loop for Out(1) / Out(2). To change between voltage and current output mode the hardware jumpers are used. There is one jumper for Out(1) and one for Out(2), so that one output can be a voltage output and the other a current output.
Page 4 7,5 mm (0,295 inches) and screw head height less than 2,5 mm (0,1 inches) Dimensions of mounting plate in mm and (inches) ® SenseAir AB (headquarter) Stationsgatan 12 Phone: +46-(0)653 - 71 77 70 Box 96 E-mail: info@senseair.com...