Download Print this page

SenseAir aSENSE VAV Installation Manual

Gas and air sensors

Hide thumbs Also See for aSENSE VAV:

Gas and Air Sensors

Push the front part with the lid upwards

while keeping the wall plate steady

Installation Manual

aSENSE VAV

1 top part

2 lid

3 front part

4 wall plate

5 screw

6 label with settings

inside the top part

Pull the top part upwards

Fold the front part with the lid forwards

and loose it from the hooks (#1)

Document

IMA0145

Rev

Page

1 (4)

Table of Contents

Do you have a question about the aSENSE VAV and is the answer not in the manual?

Page 1: Installation Manual
Gas and Air Sensors Installation Manual aSENSE VAV Dismounting of the sensor 1 top part 2 lid 3 front part 4 wall plate 5 screw 6 label with settings inside the top part Pull the top part upwards Push the front part with the lid upwards...
Page 2 The screw head height should be max 2,5 mm The top part is pushed under the Terminals and jumpers on aSENSE VAV locking hooks of the wall plate The darker positions are default settings. and is secured with a screw Terminals and jumpers are located under the top part.
Page 3: Electrical Connections
The power supply has to be connected to is considered as system ground. The same ground reference has to be used for the aSENSE VAV unit and for any connected device! Unless different transformers are used, special precautions need to be taken.
Page 4 Please use screws with screw head diameter less than 7,5 mm (0,295 inches) and screw head height less than 2,5 mm (0,1 inches) Dimensions of mounting plate in mm and (inches) SenseAir® AB (headquarter) Stationsgatan 12 Phone: +46-(0)653-71 77 70 Box 96 E-mail: info@senseair.com...