SenseAir aSENSE RL Installation Manual

Gas and air sensors

Gas and Air Sensors

Dismounting of the sensor

Push the front part with the lid upwards

while keeping the wall plate steady

Installation Manual

aSENSE RL

1 top part

2 lid

3 front part

4 wall plate

5 screw

6 label with settings

inside the top part

Pull the top part upwards

Fold the front part with the lid forwards

and loose it from the hooks (#1)

Document

IMA0197

Rev

Page

1 (4)

Table of Contents

Do you have a question about the aSENSE RL and is the answer not in the manual?

Page 1 Gas and Air Sensors Installation Manual aSENSE RL Dismounting of the sensor 1 top part 2 lid 3 front part 4 wall plate 5 screw 6 label with settings inside the top part Pull the top part upwards Push the front part with the lid upwards...
Page 2 Air of different temperature may otherwise disturb the temperature measurements. The top part is pushed under the Terminals and jumpers on aSENSE RL. locking hooks of the wall plate The darker positions are default settings. and is secured with a screw Terminals and jumpers are located under the top part.
Page 3 (halfwave rectifier). A single transformer may be used for the entire system. Note 2: aSENSE RL can deliver a voltage or a current loop for Out(1) / Out(2). To change between voltage and current output mode the hardware jumpers are used. There is one jumper for Out(1) and one for Out(2), so that one output can be a voltage output and the other a current output.
Page 4 7,5 mm (0,295 inches) and screw head height less than 2,5 mm (0,1 inches) Dimensions of mounting plate in mm and (inches) ® SenseAir AB (headquarter) Stationsgatan 12 Phone: +46-(0)653 - 71 77 70 Box 96 E-mail: info@senseair.com...