Power Supply - Dea REV Operating Instructions And Warnings

6 STANDARD PROGRAMMING
WARNING For reversible motors with electromagnetic brake, remember to set P062=3.

1 Power Supply

Give power supply, the display shows the following symbols "
*
If the control panel has already been programmed and the power fails or is switched off - once power is returned and a START command
is given, the position reset procedure is performed (see "rESP" in the table "WORKING STATUS MESSAGES" on page 31.
2 Visualisation of inputs and operations-counter status
1. Press the key for 15 seconds;
2. The display will show respectively:
Inputs status (check it's correct);
Total operations counter (* see P064):
i.g.: = 3x100* = 3000 operations performed
Maintenance operations-counter (* see P065):
i.g.: = 5*x500 = 2500 operations remaining
before the maintenance intervention request (
manoeuvres-counter disabled)
3. Hold down the key to display a cyclic 3 options, or
release the button to exit the parameter.
3 Selection type of operators
1. Scroll down the parameters with
P028;
2. Access the parameter by pressing the
3. Verify that the value corresponds to d007 (REV), otherwise, you must
select it by pressing
4. Confirm your choice by pressing the
P028).
4 Selection of direction of motion
1. Scroll down the parameters with
until you visualise P063;
2. Access the parameter by pressing the
3. Acting on and
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Confirm your choice by pressing the
returns again to P063).
Warning: The parameter automatically reverses the
motors output open/close and any limit switch input
open/close.
26
! IMPORTANT !
and keys until you visualise
key;
and keys;
key (display returns again to
and keys
key;
keys, set:
key (display
", " ", " " and then "- - - - ".
=