Replacing The Operator Panel Power Cable - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Replacing the Operator Panel Power Cable

To replace the operator panel power cable, do the following:
1. Connect the operator panel power cable to the connector at the rear of the operator panel.
2. Carefully slide the operator panel into the operator panel bay until you feel the locking tabs lock in
place. Note how the operator panel power cable must be routed through the system chassis before
being connected to the media bay chassis.
3. Connect the the operator panel power cable to the media bay.
4. Replace the media bay chassis as described in "Replacing the Media Bay Chassis" on page 39.
5. Replace the front bezel as described in "Replacing the Front Bezel" on page 11.
6. Return the system to the operating position as described in "Placing the Model 275 into the Service
and Operating Position" on page 6.
7. Reconnect the system to the power source.
8. Start the system as described in "Starting the System" on page 7.
Chapter 2. Removal, Replacement, and Installation Procedures
41