Installing Or Replacing A Power Supply With The System Power On - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Installing or Replacing a Power Supply with the System Power On

The system power can remain on when a second power supply installed or when one of two power
supplies present in the system is replaced.
To install a second power supply, or to replace a failing power supply when two are present in the system,
do the following:
1. Place the system into the service position as described in "Placing the Model 275 into the Service
and Operating Position" on page 6.
2. Remove the service access cover as described in "Removing the Service Access Cover" on page 9.
3. Ensure the power supply bay is empty by doing one of the following:
a. Remove the power supply filler by grasping the handle and pulling the filler inward and then up
and out of the system.
b. Remove a failing power supply by doing the following:
1) Remove the power cable from the rear of the failing power supply.
2) Grasp the ends of the power supply handles, and press the retractable spring-activated
portion of each handle. This action releases the spring latch located on the bottom side of
each handle. See the following illustration.
3) Lift the power supply release handles until they are perpendicular (90 degrees) to the top of
the power supply. By placing the handles perpendicular to the top of the power supply, the
base or hinged portion of each handle acts as a cam and helps pry the power supply from its
connector located on the system backplane.
4) After the power supply is released from its connector, pull the power supply straight out from
the system.
4. Grasp the power supply handles located on top of the new power supply. Pivot the power supply
handles upward to 90 degrees. This action puts the handle cams into the correct position to help seat
the power supply into its connector.
5. Carefully insert the new power supply into the power supply bay.
6. Lower the power supply handles, carefully pressing the power supply into the connector. The spring
latch located on the underside of each handle will snap into place, indicating that the power supply is
seated correctly and locked into position.
1 Power supply
2 Power supply handle (2)
3 Spring Latch (2)
46
IntelliStation POWER 9114 Model 275 Parts Guide
4 Fault LED (Amber)
5 DC Good LED (Green)
6 AC Good LED (Green)