Table of Contents
Advertisement
xth byte
Value
14+15
0
0...8192
16+17
4
0...8192
18
0
1
19
0
2C
1.. FF
20
0
1.. FF
21
1
Status
The following table lists the status information that can be read out from the reader. The byte count refers to the entry in the
acknowledgement of the "Read status" telegram.
xth byte
Value
1..
21
22+23
xx
23
yy
24
'1' .. '9'
25
xy
12
Meaning
0
0...8192
4
0...8192
ASCII
binary
CR+LF
','
Any character (not 0)
CR+LF
Any character (not 0)
LSB first
Meaning
V xx.yy
ASCII characters
V x.y
"User data start address" parameter
Specification of address from which the user data should be read (on
setting <with user data>)
"User data length" parameter
Specification of amount of user data that should be read (on setting
<with user data>)
"Data format" parameter
Setting the data transfer type: Bytes are transferred as binary bytes or
are converted into two ASCII characters.
This parameter does not apply to the separator or end character
(binary).
This parameter also does not apply to telegram traffic.
"Separator" parameter
Setting of the separator character that is transferred between data on
the setting <UID and user data>; omitted on settings <UID only> and
<user data only>
"End character" parameter
Sets the end character that is transferred at the end of a data set,
thus separating the data of different tags from each other
"Byte sequence" parameter
LSB is transferred first (within the block size)
This parameter applies only to user data.
For parameter contents, refer to the previous table
Note:
The "Physical interface" and "Transmit power" parameters are
supported only be the RF38xR reader. If these parameters are
queried on the RF310R, the parameter values or the default values
are read out as described in the "Parameters" table.
Firmware version
Hardware version
FPGA version
SIMATIC RF382R Scanmode
J31069-D0214-U001-A4-7618, 10/2013
Advertisement
Table of Contents
