Installation And Use - Summit 82061 Manual

ASSEMBLY (continued)
9. Slide the seat down onto the Arm Support Bar as
shown in figure 9.
10. Use two self tapping screws to secure the seat
webbing to the Arm Support bar. Run the screws
in from the side as shown in figure 10. A powered
screw driver works best for this step.
11. Position the arm rest pads as shown in figure
11. The cable ties for attaching the pads are "in-
line" cable ties: Note the correct and incorrect ways
of attaching. To attach - pull the cable ties snug,
cut off the excess, and rotate the clasp to the under-
side of the pad. Use two cable ties per pad.
12. Push the looped end of the cam buckle strap
through the welded wire loop on the top of the
Seat Post. Loop the strap and buckle back through
the sewn loop to create a cinch knot as shown in
figure 12.
12
5

INSTALLATION AND USE

CARRYING YOUR TROPHY CHAIR
To carry the Trophy Chair, first fold it flat. Next, take
the supplied green tourniquet buckle strap and wrap
it around the frame to secure it as shown in figure 13.
Take the long cam buckle tree strap and bring it over
your shoulder. Clip the double J-Hook into the Support
Rod slide to secure as shown in figure 14.
ATTACHING TO A TREE
1. Wrap the cam buckle strap around the tree and
hook the double J-Hook into the seat frame as shown in
figure 15.
2. Pull the free end of the strap until tight.
3. Push down on the chair to seat it on the tree.
4. Wrap the supplied green tourniquet buckle strap the
frame and the tree to secure (See figure 16).
5. Secure the seat back to the tree by wrapping the
bungee cord around the tree and clipping it to its self.
WARNING
!
Correct tightening and adjustment of the two
attachment straps is critical. All frame contact points
must be in contact with the tree before use.
PG 4
9
11
IN-LINE
CABLE
TIES
(PN 10656)
Correct
15
10
IN-LINE
CABLE
TIES
(PN 10656)
ARM PAD
(PN 74223)
Incorrect
13
16
www.summitstands.com
14