Summit 82061 Manual page 3

ASSEMBLY (continued)
3. Repeat for the other side.
4. Place two short shank bushings on the outside of the bracket
on the Arm Support Assembly as shown in figure 3.
5. Place two short shank bushings on the outside of the middle
and lower bracket on the Seat Post as shown in figure 4.
6. Place the remaining two short shank bushings on the outside
of the middle and lower bracket on the Seat Post as shown in
figure 5.
6. Position the Arm Support and Seat Post as shown in figure 6.
7. Secure each lower hole using one 3/4" bolt with lock nut
per side (see figure 7). Do not overtighten as this connection is
designed to pivot.
8. Secure each upper hole using one 3/4" bolt with lock nut
per side (see figure 8). Do not overtighten as this connection is
designed to pivot.
The Seat Frame should slide and pivot. If it does not, loosen
these bolts slightly.
3
5
7
3/4" BOLT AND LOCK
NUT- WRENCH TIGHTEN
SHORT
SHANK
BUSHING
(PN 10641)
SHORT
SHANK
BUSHING
(PN 10641)
2
LOCK NUT
(PN 10612)
4
SHORT
SHANK
BUSHING
(PN 10641)
6
ARM
SUPPORT
8
3/4" BOLT AND LOCK
NUT- WRENCH TIGHTEN
WASHER
(PN 10625)
METAL
BUSHING
(PN 10627)
3/4" BOLT
(PN 10605)
SEAT
POST
(PN 10922)
SEAT
POST
PG 3