Section 3 - Assembly; Section 4 - Installation And Use - Summit rsxHAWK Manual

3
SEAT ASSEMBLY
1. Position the RSX Seat as shown in figure 1a.
2. Starting at one corner, work the seat around the seat
support bar until it is completely secure as shown in figure
2.
2
4
INSTALLATION AND USE
WARNING
!
The use of a lineman's style climbing belt / rope is
mandatory when installing or climbing into a hang-
on treestand. NEVER attempt to install or climb into
a hang-on treestand without being stabilized by a
lineman's style climbing belt.
INSTALLATION
1. Connect a pull-up rope (not included) to your hang-on platform. The supplied green tourniquet strap with the spring loaded
buckle should be securing the seat frame to the platform. Connect one end of the pull-up to your person.
WARNING
!
ALWAYS use a pull up rope to raise and lower the
stand. NEVER climb with anything on your back.
2. USING THE SUPPLIED HARNESS AND LINEMAN'S CLIMBING BELT, Slowly and carefully climb to your desired hunting height.
WARNING
!
Climbing aids (Stick Ladders, Sectional Ladders, Steps,
etc... MUST EXTEND ABOVE the final position of the
hang-on platform. ALWAYS step down from the
climbing aid onto your platform. NEVER attempt to
climb up onto a hang-on platform from a climbing aid
mounted below the platform.
RSX SEAT
1
(PN 10917)
YOU MUST read and understand the included
Full Body Harness Instructions, Page 5, Section
5 for information on using your Lineman's Belt.
YOU MUST be wearing the supplied 4 point, full
body harness and lineman's climbing belt before
attempting to install or climb into this treestand.
NEVER rely on a tree branch for support while
climbing into or out of a hang-on treestand.
NEVER use screw in steps as they can damage the tree
and can be hazardous if you slip.
WARNING
!
WARNING
!
WARNING
!
PG 3