Summit Solo Deluxe Manual page 5

PLATFORM
1. Position the finished Seat Support and Ladder Assembly as
shown in figure 7. Note: The welded U bracket faces the
tree when fully assembled. Slide the Seat Support down onto
the Ladder Assembly and line up the bolt holes.
2. Position the Platform Assembly as shown in figure 8.
3. Slide the platform forward and line up the bolt holes from
Step 1.
4. Position the Footrest. Line it up with the same bolt holes as
Step 1 and 3. Insert a 1/4" Bushing
the Seat Support tubing. (see figure 9)
5. Secure the Footrest, Platform, Seat Support and Ladder
Section using two 2 3/4" bolts and lock nuts
Leave these bolts hand tight for now.
6. Position one of the Platform Support bars as shown in
figure 10. The bar should run from the inside of the Upright
to the outside of the Platform as shown.
7. Secure at the upper and lower hole using one
and lock nut. Leave these bolts hand tight until both bars are
attached.
8. Repeat for the opposite side.
9. Wrench tighten bolts from Steps 5 and 7.
PLATFORM
(PN 82068.100)
2 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 9
10
between the Footrest and
(see figure 10).
1 3/4" bolt
8
PLATFORM
SUPPORT
(PN 82068.030)
SEAT
SUPPORT
LADDER
ASSEMBLY
WELDED
U BRACKET
FACES TREE
BUSHING
11
1 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 9
7
TOP LADDER
SECTION
9
FOOTREST
(PN 82068.400)
EXPANDED
METAL REMOVED
FOR CLARITY
PG 5