Summit Solo Deluxe Manual page 6

STABILIZER BAR
1. Position the Female Section of the Stabilizer bar as
shown in figure 12. The Stabilizer bar will attach to the
welded U Bracket. Slide the bar into the bracket and
line up the hole.
2. Secure using one 1 3/4" bolt and lock
(see figure 13) Do not overtighten.
3. Position the Male Stabilizer bar as shown (figure 14).
Line up the bolt holes and secure using the
pin as shown in figure 15. The Stabilizer bar has several
holes to accommodate different tree sizes.
1 3/4" BOLT, LOCK NUT -
WRENCH TIGHTEN
13
1/4" WIRE LOCK PIN
15
FOAM SEAT
1. Position the Foam Seat inside the frame as shown in figure 16.
The thicker portion of the seat is the base.
2. Wrap the webbing straps over the bar and bring the buckles
together under the seat.
3. Twist the smaller three bar slide buckle slightly sideways and push
it through the larger D buckle as shown in figure 17.
4. The final buckle should look like figure 18. Repeat for the other
strap.
17
PG 6
12
nut.
Wire Lock
14
18
STABILIZER
FEMALE SECTION
(PN 82068.450)
STABILIZER
FEMALE SECTION
STABILIZER
MALE SECTION
(PN 82068.440)
FOAM SEAT
(PN 82068.850)
NOTICE
The foam seat included with this treestand is
removable for storage. DO NOT leave your stand
outdoors when it is not being used.
U BRACKET
16
www.summitstands.com