Advertisement
Temperature Sensors
LRF2-TWRB
Now that the frequency has been matched up to the Main
Repeater, proceed with device activation as specified in the
RadioRA2 Programming Utility.
1. Remove the battery from the sensor and
hold in the Test and Link buttons.
2. Continue to hold both buttons while sliding
the battery back into place. After inserting
the battery, continue holding both buttons
for about 6 seconds until the LED flashes
rapidly.
3. Press the Test button to try the next RF
channel (15 total). Press the Link button to
repeat the current channel.
4. Continue to cycle through the RF channels
until you hear the Main or Aux Repeater
beep. The beep indicates that the proper
RF channel has been identified. At this
point stop pressing any of the buttons that
change the sensor's RF channel!
5. Hold in the Test and Link buttons for about
6 seconds until the LED stops flashing.
5
Advertisement
