Summary of Contents for Lutron Electronics RadioRA2
Page 1
RadioRA2 One-Way Transmitter Frequency Changing Procedures Rev. F 11/17/2014...
Page 2
Certain devices in the RadioRA2 product family are one way transmitters (OWT). In other words, they do not receive wireless commands from other devices in the system and can only transmit or send commands to system devices.
Table of Contents and 2 Generation Ceiling Mount Sensors Generation Ceiling Mount Sensors Temperature Sensors Wall Mount Sensors Generation Pico Wireless Controls Generation Pico Wireless Controls ...8 4 Button Pico Wireless Controls All of the following procedures must always be completed with the system in device Activation mode.
5. Hold in the Test, Lights ON, and Lights OFF buttons for about 3 seconds until the dome LED stops flashing. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
6. Hold in the Button and Test button For 6 seconds until the dome LED stops rapid flashing. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
5. Hold in the Test and Link buttons for about 6 seconds until the LED stops flashing. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
5. Hold in the Test, Lights ON, and Lights OFF buttons for about 3 seconds until the dome LED stops flashing. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
5. Hold in the Open/On, Preset, and Close/ Off buttons for about 3 seconds until the LED stops flashing. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
Frequency Changing Mode. The Main and Aux Repeaters will beep once the Pico successfully exits the Mode. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.
Page 10
3 seconds to exit Frequency Changing Mode. The Main and Aux Repeaters will beep once the Pico successfully exits the Mode. Now that the frequency has been matched up to the Main Repeater, proceed with device activation as specified in the RadioRA2 Programming Utility.