Advertisement
Wall Mount Sensors
LRF2-xyLB
x = O for Occupancy; V for Vacancy
y = K for Corner; H for Hallway; W for flat Wall
Now that the frequency has been matched up to the Main
Repeater, proceed with device activation as specified in the
RadioRA2 Programming Utility.
1. Remove the battery from the sensor and
hold in the Sensor, Lights ON, and
Lights OFF buttons.
2. Continue to hold all three buttons while
pressing the battery back into place. After
inserting the battery, continue holding all
three buttons for about 3 seconds until the
LED flashes rapidly.
3. Press the LIGHTS ON button to try the next
RF channel (15 total). Press the LIGHTS
OFF button to try the previous RF channel.
Press the TEST button to repeat the current
channel.
4. Continue to cycle through the RF channels
until you hear the Main or Aux Repeater
beep. The beep indicates that the proper
RF channel has been identified. At this
point stop pressing any of the buttons that
change the sensor's RF channel!
5. Hold in the Test, Lights ON, and Lights
OFF buttons for about 3 seconds until the
dome LED stops flashing.
6
Advertisement
