Advertisement
st
1
Generation Pico Wireless Controls
RRD-P3BRL-x
x = L for Lights; S for Shades
Now that the frequency has been matched up to the Main
Repeater, proceed with device activation as specified in the
RadioRA2 Programming Utility.
1. Remove the battery from the Pico and
hold in the Open/On, Preset, and Close/
Off buttons.
2. Continue to hold all three buttons while
pressing the battery back into place. After
inserting the battery, continue holding all
three buttons for about 3 seconds until the
LED flashes about once per second.
3. Press the Open/On button to try the next RF
channel (15 total). Press the Close/Off
button to try the previous channel. Press
the preset button to repeat the current
channel
4. Continue to cycle through the RF channels
until you hear the Main or Aux Repeater
beep. The beep indicates that the proper
RF channel has been identified. At this
point stop pressing any of the buttons that
change the sensor's RF channel!
5. Hold in the Open/On, Preset, and Close/
Off buttons for about 3 seconds until the
LED stops flashing.
7
Advertisement
