Advertisement
4 Button Pico Wireless Controls
PJ2-4B
Now that the frequency has been matched up to the Main
Repeater, proceed with device activation as specified in the
RadioRA2 Programming Utility.
1. Triple tap and hold the top button of the
Pico. Hold the button for at least 15
seconds. The Pico status LED will blink
once per second to let you know that
the Pico is now in Frequency Changing
Mode.
2. Press the top or bottom buttons to cycle
through the 15 RF frequencies. Cycle
through until you hear the Main or Aux
Repeaters beep. Once you hear the beep,
that means that the proper RF channel has
been identified. At this point stop pressing
any of the buttons that change the sensor's
RF channel!
3. Press and hold the top and bottom buttons
for at least 3 seconds to exit Frequency
Changing Mode. The Main and Aux
Repeaters will beep once the Pico
successfully exits the Mode.
9
Advertisement
